MaxPower CT60 Instrukcja Naprawy Pobierz pdf (Strona 3)

English Manual: Super Power Series 60-80 25/03/2004

1 GENERAL INSTALLATION GUIDELINES

Determining the most efficient position for your thruster:

The tunnel should be placed in the deepest section of the hull and as far forward as possible.

For maximum efficiency the tunnel should be installed no less than 100 mm from the water

line.

Where the boat’s design will not allow for this submersion, any subsequent efficiency deficit

can be partly compensated using a position closer to the bow (to create greater leverage).

Decide on the most suitable configuration for both the tunnel and the electric motor.

Where necessary, the weight of the electric motor should be supported and its position

secured.

The propeller should be centred in the tunnel and should not, under any circumstance,

protrude from the opening.

Water Line

185 mm

As far forward as possible

Support

The area around the thruster should remain accessible, dry and ventilated.

The thruster can draw power from either the starter or auxiliary batteries, but use of the

source closest to the thruster is recommended.

2 TUNNEL

When the final tunnel position is determined (and all dimensions have been checked), mark the

centre of the tunnel’ position and drill a Ø 10 mm hole. Make up a metal compass from 8 mm

rod.

Do not

stratify over

this zone

Do not

stratify over

this zone

Fit compass in to the Ø 10 mm holes and trace the form of the tunnel on to the hull

(elliptical).

After cutting out the elliptic hole , disc the interior surface of the hull, by approx. 10 to 15 cm

around the holes.

The outside surface of the tunnel is then ready to be fibre-glassed.

1 2 3 4 5 6 7 8 ... 21 22

Brak uwag

MaxPower CT60 Instrukcja Naprawy Strona 3